Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 2.4 1REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B3922: FRONT WIPER FUNCTION SELECT SWITCHDIAGNOSTIC FAULT INFORMATION
2010 Saturn Vue XE, 2.4 1
Diagnostic Fault Information
2010 Saturn Vue XE, 2.4 1SECTION Diagnostic Fault Information
| Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
| WPR HI Relay B+ | 1, 2 | 1, 2 | - | - |
| Windshield Wiper Switch Signal | B3922 00 | 1 | 1 | - |
| Windshield Wiper Switch High Signal | 4 | 2 | 2 | - |
| Windshield Wiper Motor Park Switch Signal | 3 | 3 | - | - |
| WPR Relay Control | B3715 02 | 1 | 4 | - |
| WPR HI Relay Control | 4 | 2 | B3875 00 | - |
| Windshield Wiper Motor High Speed Control | 2 | 2 | 4 | - |
| Windshield Wiper Motor Low Speed Control | 1 | 1 | 4 | - |
| Windshield Wiper Switch Low Reference | - | 1, 2 | 1, 2 | - |
| Windshield Wiper Motor Ground | - | 1, 2, 3 | - | - |
| WPR Relay Ground | - | 1 | - | - |
| 1. Delay or Low Speed Wipers Inoperative 2. High Speed Wipers Inoperative 3. Wipers Do Not Park 4. Wipers Always ON |
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.