SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 2.4 1REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSCELLULAR SYSTEMS, ENTERTAINMENT SYSTEM, & NAVIGATION SYSTEMREPAIR INSTRUCTIONSCOMMUNICATION INTERFACE MODULE BATTERY REPLACEMENT
2010 Saturn Vue XE, 2.4 1

Communication Interface Module Battery Replacement

2010 Saturn Vue XE, 2.4 1SECTION Communication Interface Module Battery Replacement
Fig 1: Communication Interface Module Battery
GM1870156Courtesy of GENERAL MOTORS COMPANY
Communication Interface Module Battery Replacement

Callout Component Name
Preliminary Procedure 
Remove the right rear seat. Refer to Rear Seat Removal and Installation .
1 Communication Interface Module Battery Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Communication Interface Module Battery Assembly
Procedure 
Disconnect the electrical connectors.
  • The vehicle communication interface module (VCIM) has a specific set of unique numbers that tie the module to each vehicle. These numbers, the 10-digit station identification and the 11-digit electronic serial number, are used by the National Cellular Network and OnStar® to identify the specific vehicle. Because these numbers are tied to the vehicle identification number of the vehicle, you must never exchange these parts with those of another vehicle.
  • Replacement of the back-up battery (BUB) does not require reconfiguration of the VCIM. If a trouble code is indicated before the battery is replaced, the DTC must be cleared following the installation of the new battery. The OnStar® system does not need to be reconfigured unless the VCIM is replaced.
  • When the VCIM is replaced, the OnStar® system must be reconfigured. Failure to reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this version of the OnStar® system. This action will cause a DTC to set.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.