Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 2.4 1REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSPOWER STEERING CONTROL MODULE PROGRAMMING AND SETUPPOWER STEERING CONTROL MODULE (PSCM) REPLACEMENT & SETUP
2010 Saturn Vue XE, 2.4 1
Power Steering Control Module (PSCM) Replacement & Setup
2010 Saturn Vue XE, 2.4 1SECTION Power Steering Control Module (PSCM) Replacement & Setup
NOTE:
The power steering control module is serviced separately from the steering column assembly.
If the Power Steering Control Module is replaced, the following procedures must be performed in the following order:
- 1. PSCM reprogramming, refer to Service Programming System (SPS)
- 2. Steering Position/Torque Sensor Calibration
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.