Window Switch - Driver

2009 Saturn Astra XR, 4D Hatchback, AutomaticSECTION Window Switch - Driver
Fig 1: Window Switch - Driver Connector End View
GM814534Courtesy of GENERAL MOTORS CORP.
Window Switch - Driver

Pin Wire Color Circuit No. Function
1-7 - - Not Used
8 0.5 BU/BN 171 Power Window Master Switch Right Rear Down Signal (5 Door)
9 0.5 BU/GN 170 Power Window Master Switch Right Rear Up Signal (5 Door)
10 0.5 WH/BU 1307 Power Window Master Switch Lockout Signal (5 Door)
11 0.5 YE/BN 167 Power Window Master Switch Right Front Down Signal
12 0.5 YE/GN 166 Power Window Master Switch Right Front Up Signal
13 - - Not Used
14 0.5 BU/BK 6162 Outside Right Mirror Vertical Position Control
15 0.5 GN/BK 6161 Outside Right Mirror Horizontal Position Control
16-23 - - Not Used
24 0.5 VT/BN 169 Power Window Master Switch Left Rear Down Signal (5 Door)
25 0.5 VT/GN 168 Power Window Master Switch Left Rear Up Signal (5 Door)
26 0.5 BK 4 Accessory Voltage
27 0.5 GY 1136 Power Window Master Switch Left Front Down Signal
28 0.5 WH/GN 1300 Power Window Master Switch Left Front Up Signal
29 0.5 BN 6163 Outside Mirror Position Motor Drain Wire
30 0.5 BU/WH 6160 Outside Left Mirror Vertical Position Control
31 0.5 GN/WH 6159 Outside Left Mirror Horizontal Position Control
32 0.75 BN 1550 Ground
Connector Part Information 
  • OEM: 968265-1
  • Service: Service by Harness - See Part Catalog
  • Description: 32-Way F 0.64 Quadlock Series (BK)
Terminal Part Information 
  • Terminal/Tray: Service by Harness - See Part Catalog
  • Release Tool/Test Probe: N/A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.