Transmission Control Module (TCM) (MNF)

2009 Saturn Astra XR, 4D Hatchback, AutomaticSECTION Transmission Control Module (TCM) (MNF)
Fig 1: Transmission Control Module (TCM) (MNF) Connector End View
GM2039620Courtesy of GENERAL MOTORS CORP.
Transmission Control Module (TCM) (MNF)

Pin Wire Color Circuit No. Function
1 0.5 YE/RD 1230 Transmission Speed Sensor Signal
2 0.5 YE/BN 401 Low Reference
3 0.5 GN 772 Transmission Position Switch Bit 2 Signal
4 0.5 WH 771 Transmission Position Switch Bit 1 Signal
5 0.5 GN 1078 Ignition Key/Shifter Interlock Solenoid Lock Signal
6-9 - - Not Used
10 0.5 GN 2500 High Speed GMLAN Serial Data (+)
11 0.5 GN 2500 High Speed GMLAN Serial Data (+)
12-13 - - Not Used
14 0.5 BU/WH 5503 Low Reference
15 0.5 BN/GN 2879 Low Reference
16 0.5 WH/GN 1530 Transmission Mainline Pressure Solenoid Control
17 0.5 WH/BK 1994 TCC PWM Solenoid Valve Control
18 0.5 BK/WH 1527 Shift Solenoid Supply Voltage 3
19 0.5 BK/VT 1526 Shift Solenoid Supply Voltage 2
20 0.5 BK/GN 1525 Shift Solenoid Supply Voltage 1
21 0.75 BK 539 Run/Crank Ignition 1 Voltage
22 0.5 YE/BK 1231 Low Reference
23 0.5 YE/VT 400 Vehicle Speed Sensor Signal
24 0.5 WH/YE 1371 Transmission Position Switch Bit 4 Signal
25 0.5 GY 773 Transmission Position Switch Bit 3 Signal
26-30 - - Not Used
31 0.5 WH 2501 High Speed GMLAN Serial Data (-)
32 0.5 WH 2501 High Speed GMLAN Serial Data (-)
33-34 - - Not Used
35 0.5 BU/YE 488 Winter Mode Switch Signal
36 - - Not Used
37 0.5 BK/BU 585 Transmission Oil Temperature Sensor Signal
38 0.5 BN/BK 586 Low Reference
39 0.5 BN 2150 Ground
40 0.5 BN 2150 Ground
41 0.75 RD 3740 Battery Positive Voltage
42 0.75 BK 539 Run/Crank Ignition 1 Voltage
Connector Part Information 
  • OEM: 1241727-1
  • Service: Service by Harness - See Part Catalog
  • Description: 42-Way F MQS Series, Sealed (BK)
Terminal Part Information 
  • Terminal/Tray: Service by Harness - See Part Catalog
  • Release Tool/Test Probe: N/A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.