Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window System Controls
The power window system will operate anytime the retained accessory power (RAP) system is active or when the ignition switch is in the ACCY or ON position.
The driver window switch and passenger window switch switches are normally open, 2 position rocker type switches, with detents for up and down, pressing and holding the switch until the window is greater than a quarter of the way down and releasing the switch will activate the express down feature. The driver window switch rear passenger window switches are normally open, 2 position rocker type switches, with detents for up and down. The driver window switch rear window lockout switch is a push button type switch that provides an active signal to the driver window switch whenever pressed. Whenever the rear window lockout switch is pressed the driver window switch will activate or deactivate the rear window lockout function depending on the current state and illuminate the switch indicator whenever the function is active.
The passenger window switch contains a single power window switch that is an integral component. Closing of this normally open, rocker switch provides the passenger window switch with a request for the front passenger power window operation. The switch for the front passenger window has 2 positions up and down.
The rear passenger door power window switches are normally open, 2 position rocker type switches, with detents for up and down.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.