Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2009ASTRA XR, 2D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS AND FUEL - 1.6L (LDE OR LLU) AND 1.8L (2H0) - DTC PO341 TO DTC P2544DTC P0650CIRCUIT/SYSTEM TESTING
2009 Saturn Astra XR, 2D Hatchback, Automatic
Circuit/System Testing
2009 Saturn Astra XR, 2D Hatchback, AutomaticSECTION Circuit/System Testing
- Ignition ON, verify that the IPC warning indicators are illuminated.
- If the IPC warning indicators are not illuminated, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal and the ignition circuit fuse is open, replace the IPC.
- Ignition OFF, disconnect connector X2 at the ECM.
- Ignition ON, verify that the MIL is not illuminated.
- If the MIL is illuminated inspect the MIL control circuit for a short to ground. If the circuit tests normal, replace the IPC.
- Ignition ON, verify that the MIL illuminates with a 3A fused jumper between the MIL control circuit X2-1 and ground.
- If the MIL does not illuminate test the MIL control circuit for a short to voltage or an open/high resistance. If the circuit tests normal replace the ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.