Circuit/System Testing

2009 Saturn Astra XR, 2D Hatchback, AutomaticSECTION Circuit/System Testing
  1. Disconnect the EVAP vent pipe from the EVAP canister vent solenoid valve.
  2. Seal the EVAP vent pipe using a plug from the J 41413-300Β  .
  3. Turn ON the ignition.
  4. Command the EVAP canister purge solenoid valve to 0 percent with a scan tool.
  5. Start the engine.
  6. Observe the FTP sensor with a scan tool. The Fuel Tank Pressure Sensor parameter should be less than 1.7 volts after 90 seconds.
    • If the Fuel Tank Pressure Sensor parameter is greater than the specified range, replace the EVAP canister purge solenoid valve.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.