Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2009ASTRA XR, 2D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR, ENTERTAINMENT, AND NAVIGATIONREPAIR INSTRUCTIONSANTENNA CABLE REPLACEMENT (COUPE)INSTALLATION PROCEDURE
2009 Saturn Astra XR, 2D Hatchback, Automatic
Installation Procedure
2009 Saturn Astra XR, 2D Hatchback, AutomaticSECTION Installation Procedure
- Connect the wiring harness plug of the roof aerial.
- Install headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan) or Headlining Trim Panel Replacement (With Sunroof) or Headlining Trim Panel Replacement (Coupe) .
- Remove the rear compartment side trim panel. Refer to Rear Compartment Side Trim Panel Replacement (Coupe) or Rear Compartment Side Trim Panel Replacement (Sedan) .
- Install the radio.
- Connect the 2 wiring harness plugs.
- Push the radio into the holder until it engages.
- Install the I/P compartment.
Connect the wiring harness plug.
- Install the I/P compartment.
Tighten: Tighten the 4 screws to 4 N.m (35 lb in).
Close the I/P compartment door.
- Install the door sill inner panel.
Clip in the 5 clips.
- Connect the battery.
- For reprogramming procedures, refer to Control Module References .
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.