Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2007OUTLOOK V6-3.6LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAULREPAIR INSTRUCTIONS67. OIL PUMP ASSEMBLE
2007 Saturn Outlook V6-3.6L
67. Oil Pump Assemble
2007 Saturn Outlook V6-3.6LSECTION 67. Oil Pump Assemble
Oil Pump Assemble
1. Install the oil pressure relief valve components.
1. Install the oil pressure relief valve.
2. Install the oil pressure relief valve spring.
3. Install the oil pressure relief valve bore plug.
4. Install the oil pressure relief valve bore plug retainer C-clip.
Important: There are no serviceable components within the oil pump. Disassemble the pump only to diagnose an oiling concern. A disassembled oil pump must be replaced. DO NOT reuse a disassembled oil pump or a serviceable oil pump with a primary camshaft drive chain lower guide that needs to be replaced.
2. The dimpled surface must be face-up in the pump body.
3. Install the inner and the outer rotors in the oil pump cover in the same orientation as removed.
4. The outer rotor has a dimple to indicate the outer surface.
5. Assemble the oil pump housing and cover.
Notice: Refer to Fastener Notice.
6. Install the oil pump bolts.
Tighten the oil pump bolts to 10 N.m (89 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.