Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Saturn Vue Red Line, AWDSECTION Installation Procedure
- Install a new filter assembly.
- Install the locating pins, if removed.
- Install the clutch drum (1) to the pinion shaft (2) by shaking the drum while rotating the drum back and forth to engage the splines of the pump rotor and bushing.
- When properly engaged, the clutch drum will be fully seated against the clutch drum oil seal (1).
- Apply a continuous bead of sealer Saturn P/N 12346240 of equal height and width to the RDM housing sealing surface.
Specification: Apply sealer to a height and width of 2.5 mm (0.098 in).
IMPORTANT:
Do not disturb the sealer bead applied to the RDM sealing surface.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.