SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2006ION L4-2.0L SC VIN PREPAIR AND DIAGNOSISDIAGRAMSDIAGNOSTIC AIDSGENERAL ELECTRICAL DIAGNOSTIC PROCEDURESCONNECTOR REPAIRSBOSCH CONNECTORS (BSK)
2006 Saturn ION L4-2.0L SC VIN P

Bosch Connectors (BSK)

2006 Saturn ION L4-2.0L SC VIN PSECTION Bosch Connectors (BSK)


BOSCH CONNECTORS (BSK)

TOOLS REQUIRED
J 44020 Terminal Repair Kit

TERMINAL REMOVAL PROCEDURE
1. Disconnect the connector from the component.
2. Remove the wire dress cover if necessary.
3. Push the wire side of the terminal that is being removed toward the connector and hold it in position.




4. Insert the J 38125-561 tool into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage the terminal retainers. See the release tool cross reference in the Reference Guide of the J 44020 Terminal Repair Kit to ensure that the correct release tool is used.
5. Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.

TERMINAL REPAIR PROCEDURE
Use the appropriate wire assembly repair kits available through Saturn Service Parts.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.