Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2005VUE 2WD V6-3.5L VIN 4REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCAMSHAFT POSITION SENSORSERVICE AND REPAIR
2005 Saturn VUE 2WD V6-3.5L VIN 4
Camshaft Position Sensor: Service and Repair
2005 Saturn VUE 2WD V6-3.5L VIN 4SECTION Service and Repair
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left camshaft sprocket.
2. Remove the bolt (240), sprocket (241), bolts (242), cover (244) and seal (243).
3. Remove the bolt (723) and camshaft position (CMP) sensor (700).
INSTALLATION PROCEDURE
1. Install the camshaft position (CMP) sensor (700) and bolt (723).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolt to 4 N.m (35 lb in).
2. Install the cover (244), NEW seal (243) and bolts (242).
Tighten the bolts to 22 N.m (16 lb ft).
3. Install the left camshaft sprocket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.