Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2005VUE 2WD V6-3.5L VIN 4REPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAULREPAIR INSTRUCTIONS65. OIL FLOW CONTROL MODULE INSTALLATION
2005 Saturn VUE 2WD V6-3.5L VIN 4
65. Oil Flow Control Module Installation
2005 Saturn VUE 2WD V6-3.5L VIN 4SECTION 65. Oil Flow Control Module Installation
Oil Flow Control Module Installation
1. Install the spring (413) and valve (414). The valve must move freely in the bore.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the NEW O-ring (415), solenoid (416) and bolts (417).
Tighten the bolts to 12 Nm (106 inch lbs.).
3. Install a NEW O-ring (418).
4. Install the module (412) and bolts (436).
Tighten the bolts to 22 Nm (16 ft. lbs.).
5. Install 2 M20 x 1.5 mm nuts onto the fitting (411).
6. Install the fitting (411), if required.
Tighten the fitting to 49 Nm (36 ft. lbs.).
7. Remove the 2 M20 x 1.5 mm nuts from the fitting.
8. Install a NEW O-ring (440) and switch (437).
Tighten the switch to 22 Nm (16 ft. lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.