Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2005VUE 2WD V6-3.5L VIN 4REPAIR AND DIAGNOSISBODY AND FRAMESEATSSEAT BACKSERVICE AND REPAIRREMOVAL AND REPLACEMENTSEAT BACK LATCH RELEASE CABLE REPLACEMENT - REAR
2005 Saturn VUE 2WD V6-3.5L VIN 4
Seat Back Latch Release Cable Replacement - Rear
2005 Saturn VUE 2WD V6-3.5L VIN 4SECTION Seat Back Latch Release Cable Replacement - Rear
Seat Back Latch Release Cable Replacement - Rear
Removal Procedure
1. Remove the fastener from the rear seat back latch and pull the latch out from the seat back assembly.
2. Detach the latch cable from the latch.
3. If you are going to replace the cable, disconnect the latch cable at the seat recliner mechanism.
4. Open the J-strip at the bottom of the seat cover.
5. Pull the cable out from the seat back assembly.
Installation Procedure
1. If you are replacing the cable, route the cable through the rear seat back.
2. Connect the latch cable to the recliner mechanism.
3. Connect the J-strip at the bottom of the seat cover.
4. Connect the latch cable to the latch assembly.
Notice: Refer to Fastener Notice in Cautions and Notices.
5. Install the latch to the seat back with a fastener.
Tighten the fastener to 2.5 N.m (22 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.