Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2005 Saturn Relay AWDSECTION Installation Procedure
- Install EBCM onto the BPMV if replacing the BPMV only. Refer to Electronic Brake Control Module Replacement .
- Install BPMV and EBCM as an assembly onto the mounting bracket studs.
- Install the bolt that connects the BPMV assembly to the mounting bracket.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
- Install the BPMV bracket to the strut tower.
- Install the 3 nuts (2) that attach the BPMV mounting bracket to the strut tower.
Tighten:
- Tighten the nuts to 10 N.m (89 lb in).
- Reposition any lines or hoses that were moved out of place.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.