Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSATURN2005RELAY AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMREPAIR INSTRUCTIONSPOWER SLIDING DOOR (PSD) OPEN/CLOSE PILLAR SWITCH REPLACEMENTREMOVAL PROCEDURE

2005 Saturn Relay AWD

Removal Procedure

2005 Saturn Relay AWDSECTION Removal Procedure

Turn off the PSD from the roof console switch bank.

Fig 1: View Of Power Sliding Door (PSD) Open/Close Pillar Switch

Courtesy of GENERAL MOTORS CORP.

Remove the PSD OPEN/CLOSE switch from the center pillar.
Disconnect the electrical connector from the PSD OPEN/CLOSE switch.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.