Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2005 Saturn Relay AWDSECTION Removal Procedure
- Remove the right rear quarter lower trim panel. Refer to Trim Panel Replacement - Rear Quarter (Right) or Trim Panel Replacement - Rear Quarter (Left) in Interior Trim.
- Disconnect the electrical connectors from the power sliding door (PSD) actuator control module.
- Release the integral clips (1, 2) securing the actuator module (3) at the rear motor bracket.
- Pull the PSD actuator control module (3) inboard in order to release the control module from the actuator motor bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.