Steering Wheel Control Switch Assembly Replacement

2005 Saturn Relay AWDSECTION Steering Wheel Control Switch Assembly Replacement
Fig 1: Identifying Steering Wheel Control Switch Assembly
GM1537927Courtesy of GENERAL MOTORS CORP.
Steering Wheel Control Switch Assembly Replacement

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the steering wheel inflatable restraint module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
Radio Control Switch Replacement - Left 
1 Screws, Steering Wheel Cover (Qty: 2)

Tighten:  2 N.m (18 lb in)

2 Cover, Steering Wheel
3 Switch Assembly, Radio Controls
Tip: 
  1. Disconnect the electrical connector.
  2. Use a small flat bladed tool to remove the switch from the cover.
Radio Control Switch Replacement - Right 
4 Screws, Steering Wheel Cover (Qty: 2)

Tighten:  2 N.m (18 lb in)

5 Cover, Steering Wheel
6 Switch Assembly, Radio Controls
Tip: 
  1. Disconnect the electrical connector.
  2. Use a small flat bladed tool to remove the switch from the cover.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.