Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2005 Saturn Relay AWDSECTION Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
- Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
- Disconnect the electrical connectors from the multifunction switch.
- Remove the wiring harness (1) from the steering column harness strap (2).
- Disconnect the multifunction switch electrical connectors from the steering column wiring harness.
- Remove the multifunction switch retaining screws (1).
- Remove the multifunction switch (2) from the steering column.
- Remove the SIR coil from the steering column shaft. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.