Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2003ION 3 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (AUTOMATIC TRANSMISSION - VT25-E)REPAIR INSTRUCTIONSINPUT AND OUTPUT SPEED SENSOR ASSEMBLY INSTALLATION
2003 Saturn Ion 3 4D Sedan, Standard
Input and Output Speed Sensor Assembly Installation
2003 Saturn Ion 3 4D Sedan, StandardSECTION Input and Output Speed Sensor Assembly Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.
Install the input and output speed sensor assembly and the 2 bolts on the transmission case assembly.
Tighten
Tighten the bolts to 11 N.m (8 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.