Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2003ION 3 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (AUTOMATIC TRANSMISSION - VT25-E)REPAIR INSTRUCTIONSCONTROL VALVE BODY ASSEMBLY DISASSEMBLE
2003 Saturn Ion 3 4D Sedan, Standard
Control Valve Body Assembly Disassemble
2003 Saturn Ion 3 4D Sedan, StandardSECTION Control Valve Body Assembly Disassemble
WARNING: This page is about a different variant/trim than selected.
- Remove the manual valve (202) from the control solenoid valve assembly.
- Remove the wiring connector hole seal (200) for the control valve body cover.
- Carefully separate the control solenoid valve assembly (201) from the valve body assembly (207).
- Remove the spacer plate assembly (204). Discard the spacer plate assembly.
- Remove the fluid pump pressure screen assembly (203) from the spacer plate assembly.
- Remove the 3 ball check valves (205) from the valve body assembly (207).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.