Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2001SC1 L4-1.9L SOHC VIN 8REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULEDESCRIPTION AND OPERATIONGEARSHIFT
2001 Saturn SC1 L4-1.9L SOHC VIN 8
Gearshift
2001 Saturn SC1 L4-1.9L SOHC VIN 8SECTION Gearshift
CIRCUIT CHART
Circuit assignments for the Body Control Module (BCM) relating to gearshift:
GEARSHIFT UNLOCK
The gearshift unlock solenoid is energized by the BCM switching circuit 1135 to ground. When energized, the gearshift unlock solenoid will allow shifting from PARK. A condition for shifting from PARK is that the foot brake must be applied. The BCM receives this information over the serial data link from the engine controller.
The BCM also monitors ignition 1 circuit 39 and accessory circuit 43 to determine if the ignition switch is in the RUN or ACC position.
Circuit Chart:
Circuit assignments for the Body Control Module (BCM) relating to gearshift:
GEARSHIFT UNLOCK
The gearshift unlock solenoid is energized by the BCM switching circuit 1135 to ground. When energized, the gearshift unlock solenoid will allow shifting from PARK. A condition for shifting from PARK is that the foot brake must be applied. The BCM receives this information over the serial data link from the engine controller.
The BCM also monitors ignition 1 circuit 39 and accessory circuit 43 to determine if the ignition switch is in the RUN or ACC position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.