Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SL2 AUTOMATIC, MP6REPAIR AND DIAGNOSISENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROL SYSTEM - REMOVAL & INSTALLATION, OVERHAULCOMPUTERIZED ENGINE CONTROLSPOWERTRAIN CONTROL MODULEREMOVAL & INSTALLATION (2.2L - SATURN "L" SERIES)
2000 Saturn SL2 Automatic, MP6
Removal & Installation (2.2L - Saturn "L" Series)
2000 Saturn SL2 Automatic, MP6SECTION Removal & Installation (2.2L - Saturn "L" Series)
- Remove right side instrument panel lower dash insulator retainers. Remove right side heater outlet assembly retainer and remove outlet. Remove glove box door. Remove glove box with BCM attached. Disconnect BCM harness connectors if necessary.
- Remove PCM-to-bracket screws. Disconnect PCM harness connectors and remove PCM. To install, reverse removal procedure. Program replacement PCM using appropriate equipment and latest software. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.