Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SL2 AUTOMATIC, MP6REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROL SYSTEM - REMOVAL & INSTALLATION, OVERHAULIGNITION SYSTEMIGNITION CONTROL MODULE (C I)REMOVAL & INSTALLATION (3.8L)
2000 Saturn SL2 Automatic, MP6
Removal & Installation (3.8L)
2000 Saturn SL2 Automatic, MP6SECTION Removal & Installation (3.8L)
- Disconnect negative battery cable. Disconnect 14-pin connector at ignition control module. Disconnect spark plug wires from coil pack. Remove 6 screws retaining coils to ignition control module. Remove ignition coils from module.
- Remove screws and washers securing ignition control module to bracket. Remove ignition control module. To install, reverse removal procedure. Tighten retaining screws to specification. See TORQUE SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.