Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Functional Check
If engine is idling rough, check for a clogged PCV valve or hose. Check the PCV valve identification number to be sure the correct valve is installed. Replace as required. Use the following procedure to determine if the PCV valve is functioning properly:
- Remove PCV valve from cam cover grommet.
- Run engine at idle.
- Place your thumb over end of PCV valve to check for strong vacuum signal. If there is no vacuum present, check for clogged hose, plugged valve or plugged intake manifold port. Replace any clogged components or clean out plugged port.
- Turn off engine and remove PCV valve from hose. Shake valve and listen for the plugger to rattle inside the valve. If valve does not rattle, replace valve.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.