Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SL1 L4-1.9L SOHC VIN 8REPAIR AND DIAGNOSISCRUISE CONTROLRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIR
2000 Saturn SL1 L4-1.9L SOHC VIN 8
Cruise Control Module: Service and Repair
2000 Saturn SL1 L4-1.9L SOHC VIN 8SECTION Service and Repair
REMOVAL
1. Ignition Off.
2. Remove connector position assurance (CPA) retainer and disconnect cruise control module harness connector.
3. Disconnect cruise control rod bracket from accelerator pedal by squeezing tabs.
4. Remove nuts attaching cruise control module to steering column and remove cruise control module.
INSTALLATION
1. Install cruise control module to steering column bracket using three nuts.
Torque: 6 N.m (53 in-lbs)
2. Connect cruise control rod bracket to accelerator cable.
CAUTION: ADJUST CRUSE CONTROL CABLE EACH TIME CRUSE CONTROL MODULE IS REMOVED OR REPLACED. THROTTLE OPERATION COULD BE AFFECTED. REFER TO "CRUISE CONTROL MODULE ROD ADJUSTMENT" PROCEDURE.
3. Adjust cruise cable adjuster. Refer to "Cruise Control Module Rod Adjustment". Adjustments
1. Ignition Off.
2. Remove connector position assurance (CPA) retainer and disconnect cruise control module harness connector.
3. Disconnect cruise control rod bracket from accelerator pedal by squeezing tabs.
4. Remove nuts attaching cruise control module to steering column and remove cruise control module.
INSTALLATION
1. Install cruise control module to steering column bracket using three nuts.
Torque: 6 N.m (53 in-lbs)
2. Connect cruise control rod bracket to accelerator cable.
CAUTION: ADJUST CRUSE CONTROL CABLE EACH TIME CRUSE CONTROL MODULE IS REMOVED OR REPLACED. THROTTLE OPERATION COULD BE AFFECTED. REFER TO "CRUISE CONTROL MODULE ROD ADJUSTMENT" PROCEDURE.
3. Adjust cruise cable adjuster. Refer to "Cruise Control Module Rod Adjustment". Adjustments
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.