Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SL1 L4-1.9L SOHC VIN 8REPAIR AND DIAGNOSISCRUISE CONTROLDESCRIPTION AND OPERATIONCRUISE CONTROL SWITCH FUNCTIONSRES/ACCEL SWITCH
2000 Saturn SL1 L4-1.9L SOHC VIN 8
Res/Accel Switch
2000 Saturn SL1 L4-1.9L SOHC VIN 8SECTION Res/Accel Switch
The RES/ACCEL switch has several functions:
1. If the vehicle has been in cruise engaged mode, and cruise has been disabled by pressing the brake and/or clutch pedals, the vehicle can be returned to the original set speed by pressing the RES/ACCEL button one time. The switch must be pressed for a period greater than 0.06 seconds, but less than one second.
2. Holding the RES/ACCEL switch in the accelerate position will cause the vehicle to accelerate until the switch is released, resulting in new cruise speed. The switch must be pressed for a period greater than 1.4 seconds.
3. When cruise is engaged, tapping the RES/ACCEL switch will cause the cruise set speed to be raised in increments of 2 km/h (1 mph) for each momentary press of the RES/ACCEL switch. This is the TAP UP feature. The switch must be pressed for a period greater than 0.06 seconds, but less than 1.4 seconds.
1. If the vehicle has been in cruise engaged mode, and cruise has been disabled by pressing the brake and/or clutch pedals, the vehicle can be returned to the original set speed by pressing the RES/ACCEL button one time. The switch must be pressed for a period greater than 0.06 seconds, but less than one second.
2. Holding the RES/ACCEL switch in the accelerate position will cause the vehicle to accelerate until the switch is released, resulting in new cruise speed. The switch must be pressed for a period greater than 1.4 seconds.
3. When cruise is engaged, tapping the RES/ACCEL switch will cause the cruise set speed to be raised in increments of 2 km/h (1 mph) for each momentary press of the RES/ACCEL switch. This is the TAP UP feature. The switch must be pressed for a period greater than 0.06 seconds, but less than 1.4 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.