Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rack & Pinion Boots: Installation
2000 Saturn SLSECTION Installation
- Install NEW clamp on inner end of boot. Apply service kit grease to areas on steering gear and inner tie rod where boot will make contact when installed. Slide steering gear boot onto rod assembly until large end of boot is seated into steering gear housing groove. Ensure small pad on inner end of boot is toward front.
- Crimp inner end of boot clamp using Pliers (SA9164C). Crimp outer end of boot clamp using same pliers. Install jam nut onto inner tie rod. To complete installation, reverse remainder of removal procedure. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS . Check front wheel toe. See appropriate SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.