Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SC2 AUTOMATIC, MP6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (POWER WINDOW SYSTEM)TROUBLE SHOOTINGPRELIMINARY INSPECTION
2000 Saturn SC2 Automatic, MP6
Preliminary Inspection
2000 Saturn SC2 Automatic, MP6SECTION Preliminary Inspection
WARNING: This page is about a different car, the 2000 Chevrolet Corvette and 1999 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Using scan tool, attempt to establish communication with door control modules. If communication is not successful, repair serial data link fault first. See appropriate wiring diagram in DATA LINK CONNECTORS article in WIRING DIAGRAMS. If communication with modules is successful, retrieve all Diagnostic Trouble Codes (DTCs). Perform necessary repairs if DTCs exist. See DIAGNOSTIC TROUBLE CODE INDEX table under SELF-DIAGNOSTIC SYSTEM.
- If both windows are inoperative from master switch assembly, check fuses No. 30, 31, 33 and 34. Replace as necessary.
- If windows move slowly, ensure battery is fully charged, tand erminal contact and ground connections are okay. Ground points are located behind left and right kick panels. Check WINDOW MOTOR & REGULATOR lubrication. Ensure aftermarket equipment is properly installed. If no problem was found, repair by symptom. See SYMPTOM INDEX table under SYMPTOM TESTS.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.