Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SC2 AUTOMATIC, MP6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (BODY CONTROL MODULES)REMOVAL & INSTALLATIONFOGLIGHT/REAR HATCH SWITCH
2000 Saturn SC2 Automatic, MP6
FOGLIGHT/Rear Hatch Switch
2000 Saturn SC2 Automatic, MP6SECTION FOGLIGHT/Rear Hatch Switch
WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Carefully pry the lower edge of the foglight/rear hatch switch to release locking tab. See Fig 1. Disconnect electrical connectors and remove switch. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.