Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SC2 AUTOMATIC, MP6REPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - SELF-DIAGNOSTICSDIAGNOSTIC TESTSDTC P0508: IDLE CONTROL SYSTEM CIRCUIT LOWDIAGNOSTIC PROCEDURES
2000 Saturn SC2 Automatic, MP6
Diagnostic Procedures
2000 Saturn SC2 Automatic, MP6SECTION Diagnostic Procedures
- Start and operate engine at idle. Using scan tool, monitor IAC MOTOR CKT. - LOW VOLT test while accelerating engine using accelerator pedal to 3500 RPM and slowly returning to idle. Repeat 5 times. Then, accelerate engine to 3500 RPM and snap throttle back to idle. Repeat 5 times. If scan tool indicates TEST FAIL, go to next step. If scan tool does not indicate TEST FAIL, problem is intermittent. See DIAGNOSTIC AIDS .
- Allow engine to idle. Disconnect IAC valve harness connector. Connect IAC Tester (SA9195E) to IAC valve. Using tester, increase and decrease engine speed. If engine speed changes as commanded, go to next step. If engine speed does not change as commanded, replace IAC valve.
- Turn ignition off. Disconnect IAC tester. Disconnect PCM harness connector J1. Check continuity between ground and IAC valve harness connector terminals "A", "B", "C" and "D". If continuity does not exist on any of the circuits, go to next step. If continuity exists on any of the circuits, check and repair short to ground in affected circuit.
- Check continuity between each combination of the 4 IAC valve circuits for short to each other. Repair as necessary. If circuits are okay, replace PCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.