Fuel And Its Effects On DRIVEABILITY: Volatility

2000 Saturn SC2 Automatic, MP6SECTION Volatility
Fig 1: Fuel Volatility
G01068225Courtesy of GENERAL MOTORS CORP.

Volatility is a gasoline's tendency to change from a liquid to a vapor. Volatility is crucial to engine performance. Liquid gasoline will not burn; only vaporized gasoline burns. Once liquid fuel is injected into an intake port and mixed with air, some of it should start evaporating immediately.

Fig 2: Volatility Effects
G01068226Courtesy of GENERAL MOTORS CORP.

Any liquid's rate of evaporation changes with temperature. Temperatures in an engine vary widely. During operation, the combustion chamber temperatures may rise to more than 822°C (1500°F). Before start-up, on a very cold morning, the temperature may be zero. To burn well across the broad range, a fuel must consist of a mixture of hydrocarbons that vaporize at different temperatures.

The smaller hydrocarbon molecules vaporize at lower temperatures and the larger hydrocarbon with larger molecules vaporize at higher temperatures. The easily vaporized hydrocarbons, which are easy to burn, are called the "light-ends." They help with quick starts when the engine is cold. The less volatile "heavy-ends" contribute more to engine power; but because they are harder to burn, they can coat the cylinder walls without burning and in extreme cases may dilute the oil in the crankcase.

Lower volatility is desirable in the summer to prevent excessive premature evaporation of the fuel. In the winter, high volatility is desirable because the fuel must vaporize quickly for cold starts and good cold driveability.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.