Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Air Bag (Inflator) Module: Removal
Disable SIR system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Remove upper steering column shroud bolts, located on outer edges of lower shroud, and remove shroud. Turn steering wheel to 3 o'clock position. Insert short, flat screwdriver into one of triangular holes in steering wheel shroud. Turn screwdriver to release spring fastener while lifting on corner of air bag closest to fastener. Repeat this for next nearest triangular hole. Turn steering wheel to 9 o'clock position. Release spring fasteners of other pair of triangular holes. Disconnect wiring harness from air bag module. Remove module.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.