Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SC2 AUTOMATIC, MP6REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMREMOVAL AND INSTALLATIONFUEL PUMP MODULEREMOVAL
2000 Saturn SC2 Automatic, MP6
Fuel Pump Module: Removal
2000 Saturn SC2 Automatic, MP6SECTION Removal
NOTE:
Clean all fuel pipe and hose connections and surrounding areas before disassembling to avoid possible contamination of the fuel system. Spray the fuel pump module cam-lock ring tang with penetrating oil prior to attempting removal.
- Remove fuel tank. Refer to FUEL TANK .
- Disconnect fuel feed and return lines from filter/pressure regulator.
- Disconnect fuel pump vapor line from fuel tank vent pipe.NOTE: To prevent retainer damage, do not attempt to remove the retainer with a 12 in. or shorter ratchet/breaker bar.
- Use the Fuel Tank Lock Ring Remover SA9156E and remove the fuel pump module retaining ring. A 1/2 in. breaker bar (approximately 18 inches long) will easily loosen and remove the lock ring.
- To prevent bending of the sending unit float arm during removal, lift the pump module up slightly to disengage the orientation tabs in the tank and rotate the module 90° clockwise until the fuel lines are facing the 1 o'clock position (12 o'clock is front of tank).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.