Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SC2 AUTOMATIC, MP6REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALINDUCTION SYSTEMREMOVAL & INSTALLATIONACCELERATOR CONTROL CABLEREMOVAL
2000 Saturn SC2 Automatic, MP6
Accelerator Control Cable: Removal
2000 Saturn SC2 Automatic, MP6SECTION Removal
NOTE:
Accelerator and cruise control cables should not be lubricated. If a binding condition exists with the cable itself, replace the cable assembly.
- Remove the PCV valve from the cam cover and rotate it up and away from the throttle cable.
- Release accelerator control cable from the throttle lever.
- Release cable retainer locking tangs from accelerator control cable bracket.
- Release accelerator control cable from accelerator pedal assembly.
- Release cable retainer locking tangs from dash panel. Use wrench to aid in depressing the throttle cable retaining tabs. View illustrates throttle cable in the installed position.
- Remove both coolant surge tank retainer screws. Move the windshield washer fluid bottle off to the side. Lift the coolant surge tank up and out of its locating holes and disconnect the electrical harness from the low coolant sensor.
- Remove the accelerator cable retaining clip from the right front suspension strut attachment bolt. Remove the retaining clip at the right strut tower (replacement accelerator cable assembly is supplied with a new retainer clip). Remove the cable from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.