Torque Specifications

2000 Saturn SC2 Automatic, MP6SECTION Torque Specifications
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Axle Shaft-To-Hub Nut 148 (200)
Caliper-To-Steering Knuckle Bolts 81 (110)
Intermediate Shaft Support Bracket
To-Engine Block Bolts 40 (54)
To-Intake Manifold Bracket Bolt (Lower) 22 (30)
Strut-To-Steering Knuckle Bolts 126 (170)
Tie Rod End Nut 19 (25) + 134 Degrees
Tie Rod Linkage Installer 33 (45)
Wheel Lug Nuts 103 (140)
INCH Lbs. (N.m)Β 
ABS Wheel Speed Sensor-To-Steering Knuckle Bolt 71 (8)
Ball Joint Stud Castle Nut 55 (6.2)
Intermediate Shaft Bracket-To-Intake Manifold Bracket Bolt (Upper) 71 (8)
Intermediate Shaft Cover Bolts 88 (10)
Intermediate Shaft Cover Nut 71 (8)
Underbody Front Air Deflector Assembly 53 (6)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.