Left Hand Drive Vehicles

2000 Saturn SC1 L4-1.9L SOHC VIN 8SECTION Left Hand Drive Vehicles

Cruise Control Module Rod Adjustment:




1. Observe position of throttle linkage to make sure the linkage is resting on the throttle stop screw.
2. Depress cruise cable adjuster release tabs and slide adjuster away from the module.
3. Ignition On, engine Off.
4. Using Scan tool, note TP sensor voltage.
5. Move adjuster in toward module until a 1-2 mm (0.040-0.079 in.)clearance is between the adjuster and the accelerator pedal bracket. There should be a very slight amount of play in the accelerator cable.

IMPORTANT: 1-2 mm (0.040-0.079 in.) is approximately one click movement of the adjuster.

NOTE: Driveability concerns may result if the cruise control rod is not adjusted properly.

6. Using Scan tool, make sure TP sensor voltage is not greater than the voltage noted before the adjustment procedure was performed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.