Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Crankshaft Position (CKP) Sensor Variation Learn Procedure
2000 Saturn LW2 AutomaticSECTION Crankshaft Position (CKP) Sensor Variation Learn Procedure
- Procedure must be performed if any of the following have been done or exist:
- EEPROM was reprogrammed.
- If Diagnostic Trouble Code (DTC) P1336 exists.
- If crankshaft, crankshaft position sensor, engine or Powertrain Control Module (PCM) have been replaced.
- Any repairs have been performed that disturbs the crankshaft or vibration damper to the crankshaft position sensor relationship.
- CKP sensor variation compensating values are stored in PCM after a learn procedure has been performed. If actual CKP sensor values are not within specification, DTC P0300 will be stored in the PCM.
- Ensure battery is fully charged. Ensure cable is properly connected on Data Link Connector (DLC). Apply parking brake. Block front wheels. Ensure hood is closed.
- Place transaxle in Park (A/T models) or Neutral (M/T models). Ensure all accessories are off. Start engine and warm engine until engine coolant temperature is at least 185°F (85°C).
- Apply service brakes. With engine idling, use scan tool to select and enable CKP sensor variation learn procedure.
- Accelerate engine until CKP sensor variation learn procedure fuel cut off is obtained and engine starts to decelerate or cut out. Quickly release throttle to idle position once CKP sensor variation learn procedure is obtained and engine decelerates or cuts out. Once CKP sensor variation values are learned, the PCM will return engine control to the operator and engine will respond to throttle position.CAUTION: Ensure throttle is quickly released to idle position once CKP sensor variation learn procedure fuel cut off is obtained and engine starts to decelerate or cut out.
- Using scan tool, verify that CKP sensor variation learn procedure was completed. If CKP sensor variation learn procedure was not completed, go to next step. If CKP sensor variation learn procedure was completed, shut engine off and remove scan tool.
- If CKP sensor variation learn procedure was not completed, repeat entire procedure up to 10 times. If PCM will not learn the CKP sensor variation compensating values, a DTC P1336 should be stored in the PCM. Perform test procedures for DTC P1336 and repair as necessary. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.