Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Crankshaft Position (CKP) Sensor Variation Learn Procedure (5.7L)
2000 Saturn LW2 AutomaticSECTION Crankshaft Position (CKP) Sensor Variation Learn Procedure (5.7L)
- Procedure must be performed if any of the following have been done:
- EEPROM was reprogrammed.
- If crankshaft position sensor was removed or replaced.
- Powertrain Control Module (PCM) has been replaced.
- Install scan tool on Data Link Connector (DLC). Apply parking brake. Block rear wheels. Ensure hood is closed. Ensure transmission is in Park (A/T models) or Neutral (M/T models). Start engine and allow engine to idle until engine coolant temperature is at least 150°F (65°C). Ensure all accessories are off.
- Apply brakes. Ensure brakes remain applied during remaining duration of this procedure. Using scan tool, select and enable CKP sensor variation learn procedure.
- Gradually accelerate engine to 4000 RPM. Quickly release throttle to idle position once CKP sensor variation learn procedure is obtained and engine starts to decelerate. Once CKP sensor variation values are learned, the PCM will return engine control to the operator and engine will respond to throttle position.
- If CKP sensor variation learn procedure was not terminated, turn ignition off for at least 15 seconds. CKP sensor variation learn procedure is complete. If CKP sensor variation learn procedure was terminated, turn ignition off. Refer to Diagnostic Trouble Code (DTC) P1336 for additional diagnostic information. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.