Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LW2 AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - SELF-DIAGNOSTICSSELF-DIAGNOSTIC SYSTEMDIAGNOSTIC PROCEDURE
2000 Saturn LW2 Automatic
Diagnostic Procedure
2000 Saturn LW2 AutomaticSECTION Diagnostic Procedure
Diagnosis of computerized engine control system should be performed in the following order:
- Ensure all engine systems not related to computer system are operating properly. DO NOT proceed with testing unless all other problems have been repaired. On-Board Diagnostic (OBD) system check must be performed before using specific DTC testing procedure. See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK .
- If DTCs were displayed, determine whether DTCs are hard or intermittent. Hard DTCs will cause MIL to illuminate continuously while engine is running. See HARD OR INTERMITTENT TROUBLE CODE DETERMINATION . For diagnosing hard DTCs, proceed to appropriate DTC test. See DIAGNOSTIC TESTS . For diagnosing intermittent DTCs, see appropriate TROUBLE SHOOTING - NO CODES article.
- If no DTCs are present and a driveability problem exists, refer to SYMPTOMS in appropriate TROUBLE SHOOTING - NO CODES article. Doing so will help identify proper system or component to check in appropriate SYSTEM & COMPONENT TESTING article.
- After necessary repairs are made, clear DTCs, verify vehicle will enter "closed loop" operation and ensure DTC does not reset.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.