Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LW1 L4-2.2L VIN FREPAIR AND DIAGNOSISCRUISE CONTROLBRAKE SWITCH (CRUISE CONTROL)SERVICE AND REPAIRSTOPLAMP SWITCH
2000 Saturn LW1 L4-2.2L VIN F
Stoplamp Switch
2000 Saturn LW1 L4-2.2L VIN FSECTION Stoplamp Switch
REMOVAL
1. Remove left lower I/P closeout panel (hush panel) push pins and remove.
2. Disconnect electrical connector.
3. Disconnect switch by rotating it 180 degrees and then pull out of bracket.
INSTALLATION
1. Install switch into bracket and rotate 180 degrees.
2. Install electrical connector.
3. Install left lower I/P closeout panel (hush panel).
4. Disconnect cruise throttle cable from module by rotating 1/4 turn counterclockwise.
5. Remove cable from connecting strap.
6. Remove cruise control module.
INSTALLATION
1. Connect cruise control throttle cable to cruise control module connecting strap.
IMPORTANT: Do not twist connecting strap during installation.
2. Install cruise control throttle cable to cruise control module by rotating 1/4 turn clockwise.
3. Install cruise control module to bracket.
4. Install cruise control throttle cable tab to throttle body cam.
5. Adjust cruise control throttle cable and lock in adjuster.
6. Install electrical connector.
1. Remove left lower I/P closeout panel (hush panel) push pins and remove.
2. Disconnect electrical connector.
3. Disconnect switch by rotating it 180 degrees and then pull out of bracket.
INSTALLATION
1. Install switch into bracket and rotate 180 degrees.
2. Install electrical connector.
3. Install left lower I/P closeout panel (hush panel).
4. Disconnect cruise throttle cable from module by rotating 1/4 turn counterclockwise.
5. Remove cable from connecting strap.
6. Remove cruise control module.
INSTALLATION
1. Connect cruise control throttle cable to cruise control module connecting strap.
IMPORTANT: Do not twist connecting strap during installation.
2. Install cruise control throttle cable to cruise control module by rotating 1/4 turn clockwise.
3. Install cruise control module to bracket.
4. Install cruise control throttle cable tab to throttle body cam.
5. Adjust cruise control throttle cable and lock in adjuster.
6. Install electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.