Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
PASS-Key(R) III System Quick Learn Procedure
2000 Saturn LW1 AutomaticSECTION PASS-Key(R) III System Quick Learn Procedure
- Insert a valid Master ignition key in the ignition switch. Start engine. After 10 seconds, turn ignition off and remove key.
- Within 10 seconds, insert new valid mechanical code unlearned key and turn ignition switch to RUN position. Security light will illuminate until key is learned. This may happen so quickly light is not observed. Turn ignition off and remove key 10 seconds after light goes out. To learn additional keys, repeat this step.
NOTE:
RIM may be referred to as BCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.