Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Torque Converter Clutch (TCC) Solenoid (Except 1.9L)
2000 Saturn LW1 AutomaticSECTION Torque Converter Clutch (TCC) Solenoid (Except 1.9L)
NOTE:
Some solenoids may have an internal pressure switch in series with the solenoid winding and will not show continuity until transmission hydraulic pressure is applied.
Disconnect Torque Converter Clutch (TCC) solenoid harness connector. Using DVOM, measure resistance between appropriate TCC solenoid terminals. Solenoid resistance should be greater than 20 ohms.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.