Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Shift Indicator - A/T: Service and Repair
2000 Saturn LS2 V6-3.0L VIN RSECTION Service and Repair
REMOVAL
1. Pull up on control boot until indicator bezel disengages from console.
2. Disconnect electrical connector from indicator bezel.
3. Pull boot up around control knob to access shift control indicator. Disengage tabs on indicator and remove.
INSTALLATION
1. Install shift control indicator into indicator bezel.
2. Connect indicator bezel electrical connector.
3. Install indicator bezel into console opening.
1. Pull up on control boot until indicator bezel disengages from console.
2. Disconnect electrical connector from indicator bezel.
3. Pull boot up around control knob to access shift control indicator. Disengage tabs on indicator and remove.
INSTALLATION
1. Install shift control indicator into indicator bezel.
2. Connect indicator bezel electrical connector.
3. Install indicator bezel into console opening.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.