Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LS2 V6-3.0L VIN RREPAIR AND DIAGNOSISCRUISE CONTROLBRAKE SWITCH (CRUISE CONTROL)SERVICE AND REPAIRSTOPLAMP SWITCH
2000 Saturn LS2 V6-3.0L VIN R
Stoplamp Switch
2000 Saturn LS2 V6-3.0L VIN RSECTION Stoplamp Switch
REMOVAL
1. Remove left lower I/P closeout panel (hush panel) push pins and remove.
2. Disconnect electrical connector.
3. Remove switch by rotating 180 degrees and then pull it out of the bracket.
INSTALLATION
1. Install switch into bracket and rotate 180 degrees.
2. Connect electrical connector.
3. Adjust cruise brake switch.
a. Depress brake pedal.
b. Pull-out plunger on brake switch.
c. Lift-up on brake pedal.
4. Install left lower I/P closeout panel (hush panel).
1. Remove left lower I/P closeout panel (hush panel) push pins and remove.
2. Disconnect electrical connector.
3. Remove switch by rotating 180 degrees and then pull it out of the bracket.
INSTALLATION
1. Install switch into bracket and rotate 180 degrees.
2. Connect electrical connector.
3. Adjust cruise brake switch.
a. Depress brake pedal.
b. Pull-out plunger on brake switch.
c. Lift-up on brake pedal.
4. Install left lower I/P closeout panel (hush panel).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.