Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Disabling System (Saturn "S" Series)
2000 Saturn LS1 AutomaticSECTION Disabling System (Saturn "S" Series)
- Turn front wheels to straight-ahead position. Turn ignition off and remove key. Remove AIR BAG fuse from fuse block. Fuse block is located behind access cover on right side of center console. Remove Connector Position Assurance (CPA) clip from driver air bag Yellow 2-pin connector. Connector is clipped to steering column brace. Disconnect Yellow 2-pin connector.
- Remove glove box. Detach clip holding passenger air bag Yellow 2-pin connector to metal brace. Brace is near blower motor. Remove CPA clip and disconnect passenger air bag Yellow 2-pin connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.