Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Activating System (Lumina)
2000 Saturn LS1 AutomaticSECTION Activating System (Lumina)
- Remove key from ignition switch. Connect passenger air bag Yellow 2-pin air bag connector behind glove box. Install CPA clip. Install glove box and sound insulator panel.
- Connect driver air bag Yellow 2-pin air bag connector at base of steering column. Install CPA clip. Install sound insulator panel.
- Install fuse No. 21 in fuse block. Staying well away from air bag modules, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7 times, and then turns off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.