Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Change Oil Soon Lamp - Illuminates Too Soon
2000 Saturn LS L4-2.2L VIN FSECTION Change Oil Soon Lamp - Illuminates Too Soon
BULLETIN NO: 00-T-26
ISSUE DATE: May, 2000
CATEGORY TYPE: Engine-09
CATEGORY: Emission Controls
CORPORATION NO: 00-06-04-017
SUBJECT:
Change Oil Soon Lamp Illuminated With Low Mileage (Install New ECM/PCM Calibration)
MODELS AFFECTED:
2000 Saturn L-Series vehicles
CONDITION:
Some customers may comment about the Change Oil Soon lamp illuminating at lower mileage than expected after the lamp has been reset.
CAUSE:
A software calibration in the ECM/PCM determines when to illuminate the Change Oil Soon lamp based upon the number of crankshaft revolutions and coolant temperature. The total number of crankshaft revolutions necessary to illuminate the change oil soon lamp was insufficient.
CORRECTION:
Install new ECM/PCM calibration according to the following calibration table. Refer to "Service Programming System (SPS)" in the Saturn Service Stall System (SSS) User Guide for reprogramming procedures.
ECM/PCM CALIBRATIONS (CALIBRATION ID)
CLAIM INFORMATION:
To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System for J6355 (EE PROM-Reprogramming), or if another procedure is performed, refer to the appropriate Electronic Labor Time Guide for the correct Labor Operation Code and Time.
Disclaimer
ISSUE DATE: May, 2000
CATEGORY TYPE: Engine-09
CATEGORY: Emission Controls
CORPORATION NO: 00-06-04-017
SUBJECT:
Change Oil Soon Lamp Illuminated With Low Mileage (Install New ECM/PCM Calibration)
MODELS AFFECTED:
2000 Saturn L-Series vehicles
CONDITION:
Some customers may comment about the Change Oil Soon lamp illuminating at lower mileage than expected after the lamp has been reset.
CAUSE:
A software calibration in the ECM/PCM determines when to illuminate the Change Oil Soon lamp based upon the number of crankshaft revolutions and coolant temperature. The total number of crankshaft revolutions necessary to illuminate the change oil soon lamp was insufficient.
CORRECTION:
Install new ECM/PCM calibration according to the following calibration table. Refer to "Service Programming System (SPS)" in the Saturn Service Stall System (SSS) User Guide for reprogramming procedures.
ECM/PCM Calibration:
ECM/PCM CALIBRATIONS (CALIBRATION ID)
CLAIM INFORMATION:
To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System for J6355 (EE PROM-Reprogramming), or if another procedure is performed, refer to the appropriate Electronic Labor Time Guide for the correct Labor Operation Code and Time.
Disclaimer To Customer:
Disclaimer
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.