Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LS AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESANALOG INSTRUMENT PANELSSYSTEM TESTSTEST B: COOLANT TEMPERATURE GAUGE INACCURATE/INOPERATIVE
2000 Saturn LS Automatic
Test B: Coolant Temperature Gauge Inaccurate/Inoperative
2000 Saturn LS AutomaticSECTION Test B: Coolant Temperature Gauge Inaccurate/Inoperative
NOTE:
If coolant gauge is inaccurate, use scan tool in BCM mode to read coolant gauge position from BCM.
- Connect scan tool to DLC. Start engine. Using scan tool, access engine coolant temperature. If scan tool displays engine coolant temperature, go to next step. If scan tool does not display engine coolant temperature, repair engine coolant temperature signal circuit as necessary. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
- Using scan tool, perform instrument panel cluster LAMP and GAUGE SWEEP tests. If coolant temperature gauge sweeps properly, check for intermittent poor connections. If coolant temperature gauge does not sweep properly, replace instrument cluster.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.